Early January I decided that instead I would start up a new hobby and possibly very small buisness doing CNC cutouts and engraving. Long story short it turns out that you have to know even the slightest bit of what your doing past being able to assemble the machine.
So I have sitting in my garage all set up an awesome CNC Router with a quality controller, water pump, a few router bits for it for cutting/engraving and the machine has never been past the flip the switch and test the motor stage.
Since I've got a machine sitting in the garage collecting dust that hasn't ever been used I'm sure that everyone can imagine how impressed my wife is so I'm afraid it has to go.
I bought the machine for ~$2060
Pickup will be in Hoppers Crossing or I may be able to deliver nearby.
I'm not sure on a reserve but obviously I would like to recoup as much as possible.
Reserve - $1100
So I have sitting in my garage all set up an awesome CNC Router with a quality controller, water pump, a few router bits for it for cutting/engraving and the machine has never been past the flip the switch and test the motor stage.
Since I've got a machine sitting in the garage collecting dust that hasn't ever been used I'm sure that everyone can imagine how impressed my wife is so I'm afraid it has to go.
I bought the machine for ~$2060
Pickup will be in Hoppers Crossing or I may be able to deliver nearby.
I'm not sure on a reserve but obviously I would like to recoup as much as possible.
Reserve - $1100